DUROSTICK D-6 - fiber reinforced cement mortar for thicknesses 2-5cm / layer
DUROSTICK D-6 25kg
Warning: Last items in stock!
Ready, fiber reinforced, leveling mortar that just by adding water and stretches easily worked (Fig.1).
Has excellent rheological properties that make it necessary for casting purposes and spirit level (Figure 2), for any kind of investment in flooring.
Does not corrode pipes (like traditional materials with sea sand), no crack, have high mechanical strength and is resistant to frost and humidity.
Classified as CT-C20-F4-AR4-A1fl according to EN 13813 (CERECO Code: 137A / 2009).
(Measurement conditions 23 ° C and 50% R.H.)
Form - Colour
Fiber-reinforced cementitious powder - Grey
Toxic / flammable (according to EN 88/379)
Bulk density of dry mortar
1,45 ± 0,05 kg / lt
Bulk density of fresh mortar
1,90 ± 0,05 kg / lt
Maximum grain diameter
4,5 lt water to 25 kg of cement
From +5 ° C to +35 ° C
Temperature resistance from -20 ° C to +80 ° C
Pot life At least 2 hours
After 12 hours
After 4-6 days
Resistance 28 days in accordance with EN 13892-2:
5,00 ± 0,50 N / mm²
Compressive strength according to EN 13892-2 in:
• 24 hours
4,50 ± 1,50 N / mm²
• 7 days
15,00 ± 1,00 N / mm²
• 28 days
22,00 ± 1,00 N / mm²
• Resistance 28 days in traction during EN13892-8:
≥ 0,80N / mm²
• Abrasion resistance BCAkata EN 13892-4: 400 ± 80mm
Experimental measurements were performed according to EN 13813 sto Existing laboratory DUROSTICK and confirmed by checking CERECO (137A / 2009 code).
NB .: The addition of 1,4 kg / sack DUROSTICKDS-76 plasticizer and accelerator helps increase the rheology of the cement and to accelerate hardening. The pumping of cement from long distance is facilitated with the result that "boukonoun" transfer tubes.
The DUROSTICK D-6 are ideal as a substrate before laying tiles, marble, parquet, trowelled screed indoors or outdoors. It is the ideal solution because of its high industrial quality and are absolutely necessary when finding good quality aggregates (washed sea sand or river appropriate particle size) is difficult.
1. Surface preparation
The substrates must be clean, free of loose materials, dust, oils and wetted before application.
Pour the cement into 4,5-5lt clean water and mix with a low speed drill or mixer.
The laying of the material is such that the concrete.
For heating, the addition ACRYLIC EMULSION or D-20 by DUROSTICK in mixing water at a ratio of 1: 1, increases the flexibility of D-6 of DUROSTICK, which is necessary for this application.